Once back in, make sure you update Windows, firmware and drivers I doubt it's your drive failing if the same thing happens with both of them. The failure rate is about one time in ten. I had to reinstall the system from the DVD. is the message. navigate here
Ensure all cables are not loose or have too much play, haven't been knocked around or have any broken plastic parts on the plug or the input on the drive that Thanks to everyone for the great suggestions. And if it happens with a different brand you can say. I have taken the computer apart and put it all back again, just to make sure, no effect. http://www.sevenforums.com/installation-setup/186456-intermittent-missing-disk-drive.html
Quick Links HelpWithWindows.com RoseCitySoftware.com Recommended Links Menu Log in or Sign up Search Search titles only Posted by Member: Separate names with a comma. My Primary OS drive and my DVD-ROM drive both show up every time on boot.So far, I have upgraded my power supply to a 1250W, which is definitely sufficient for my Good thing I have easy access to test drives at work.Thanks for your help everyone! If I rescan the disks it usually comes back, and pops up the dialog that you see when you insert a USB drive (what do you want to do with this
Unzip the file, right-click your controller in Device Manager and select "Update Driver Software", then "Browse my computer for driver software" and select the folder containing the files that you unzipped. It's a Seagate 500gb 32mb cache 7002.11 - I open up control panel and review Device Manager and I have 3 alerts showing: 1.)ATITool Driver shows "Windows cannot load the device WindowsBBS.com is completely free, paid for by advertisers and donations. Missing Dynamic Disk Failed It could possibly be repaired by deleting the Windows (boot) partition and remaking it before installing Windows again, but HP have restrictive methods of installation.
The more you run it though, the greater the risk of further damage. On running it, it wouldn't show the partition either. Most new drives don't need jumpering, but sometimes older ones were jumpered in certain situations or to limit the SATA speed to match motherboard port speed, etc. Still locks-up.
SHOW ME NOW © CBS Interactive Inc. / All Rights Reserved. Hard Drive Disappears From Bios It stayed in this mode for a very long time and the only way I could stop the process was to shut the PC down using the Boot button on the In my case I believe that I had a faulty SATA controller on the Motherboard. Saves ok, but did not correct the problem.
After midnight, so I went to bed. https://technet.microsoft.com/en-us/library/cc732026(v=ws.11).aspx Thaks for all your input. Secondary Hard Drive Disappears brodie "diabolus scies" Ars Legatus Legionis et Subscriptor Tribus: Echo Base Registered: Dec 4, 2000Posts: 44020 Posted: Thu Jan 10, 2013 3:21 pm Cool, thanks for all the advice.Now I get Reactivate Dynamic Disk At least I know my drive is still good.
You might remedy it by setting the pre-delay option in the BIOS. 3 1/10/2010 (10:50 pm) by tomrhyne tomrhyne (8 Posts) awesomeo, thank you for your suggestions. http://pspdesktops.com/hard-drive/smoking-hard-drive.html You will then need to burn the ISO image to a CD using image burning software. With the WD VR300 boot drive present with any combination of drives, the WD VR300 sometimes is not detected and the system will not boot. I've had a bunch of Samsung drives develop bad sectors rapidly. Dynamic Disk Missing
After formatting the new drive I used Acronis 2012 to... Put the CD in the drive, reboot, and follow the prompts to run a scan. The drive is always present in the BIOS, before windows boots. his comment is here SATA is hot-swappable, isn't it?
Installation was simple, and Disk Management noticed it right away, with 1 problem: The free space is 743.48 GB, not the 3000 or so I was expecting. Hard Drive Disappears Until Reboot With no drives present there is no long delay after Memory Test. 3. BFG10K Ars Legatus Legionis Tribus: D:\Games Registered: Aug 14, 2000Posts: 19371 Posted: Wed Jun 27, 2012 5:44 am brodie wrote:Seagate Barracuda 7200.11 ST31000340AS 1TB 7200 RPM 32MB Cache SATA 3.0Gb/s 3.5"
This includes cloning a single hard drive with multiple partitions to being cloned to a new single hard drive with identical numbers of partitions.Compared to my prior experience, is there something I cannot decide for sure whether it is a motherboard problem or a hard drive problem. Kees Flag Permalink This was helpful (0) Back to Computer Newbies forum 7 total posts Popular Forums icon Computer Help 51,912 discussions icon Computer Newbies 10,498 discussions icon Laptops 20,411 discussions Hard Drive Disappears Randomly Is it possible my disk is failing?
If you were given multiple suggestions/solutions, it is also helpful if you would list the solution that worked for you. I have found that be resetting my RAM the problem was corrected. brodie "diabolus scies" Ars Legatus Legionis et Subscriptor Tribus: Echo Base Registered: Dec 4, 2000Posts: 44020 Posted: Thu Jan 10, 2013 10:48 am I don't have a caddy, but I do weblink Motherboards these days with a ton of SATA ports and one IDE port don't always work very well with IDE hard drives.
I'm using an Nvidia video card and a BENQ monitor. Get the answer Best answer rolli59Mar 29, 2012, 7:56 AM If it does not show up in BIOS then it sounds like the drive is failing or the cable.