Home > Bsod After > BSOD After Verifier.exe Kernel Power Event ID:41

BSOD After Verifier.exe Kernel Power Event ID:41

Was trying to monitor/control my gpu under stress testing. I'm not getting blue screens when it restarts hence no minidump files either. Oh, and you can ignore all those errors about the bad hard drive sector. General: The system firmware has changed the processor's memory type range registers (MTRRs) across a sleep state transition (S4). have a peek here

Baby NapoleonJun 18, 2015, 10:48 PM Hi Johnbl,Thanks for your reply. CPU's are run on clock sweeps. All of my drivers are current*. They were Application Error Event ID 1000 Task Category 100 where chrome.exe was the faulting application.

The differing error codes are usually symptomatic of a lower level problem within the system. Back to top #4 Cassius88 Cassius88 Topic Starter Members 7 posts OFFLINE Local time:07:57 PM Posted 24 July 2015 - 03:46 AM Furmark screenshot after 30 minutes. when i started full scan using malwarebytes ,it freezes when scan reach to windows/winsxs microsoft windows comman controls something folder and stops responding. I'll try all that when I get to the hardware side of troubleshooting; right now I'm still focused on exploring the possibility of it being software related.

WARNING: event 11 Wininit : custom dynamic link libraries are being loaded for every application.. That is a hazard. Last night I booted from the windows cd to go into the recovery environment so I could attempt some repairs and it listed my installation as "Windows 7 x64 (recovered)". If it's hardware then it has to be the psu.

I have the Knack. ** If I haven't replied in 48 hours, please send me a message. I strongly encourage and appreciate all feedback cuz I'm about to lose my mind over this problem. CPU heat looks quite high, but am not sure what it is supposed to be. Can I just confirm that on RamMap I have only selected "Empty Standby List" from the "Empty" menubar; is this correct?Thanks again,BN.

You can also test it in Device Clean Boot mode: ย  Device Clean Boot ================= 1. I recently purchase parts from newegg.com and built a custom gaming rig. BugCheck C4, {f6, 134, fffffa8008857b30, fffff8800d4d58f9} *** WARNING: Unable to verify timestamp for gdrv.sys *** ERROR: Module load completed but symbols could not be loaded for gdrv.sys Probably caused by : Could there be another underlying issue too?Thanks again,BN.

No errors were recorded. Join Date Sep 2009 Location MS Gulf Coast Kernel-Power Event ID 41 Critical Error I don't know if I'm putting this in the right subforum, but here it goes. Software can't always find hardware problems, because hardware runs at a lower level. I'd suggest running the OCCT Power Supply test overnight or so; this basically runs the other tests simultaneously to achieve maximum draw from your PSU.

My dad upgraded to windows 8 beta to get rid of the problems (constant freezing, unable to startup), but now I'm getting the same problems and BSoD that tell me that http://pspdesktops.com/bsod-after/bsod-after-selecting-hibernate-in-windows-8-pro-x64.html If MS Security software was making systems reboot, I can assure you, you'd hear it screamed from 100 Million rooftops, nightly. BUGCHECK_STR: 0x3B DEFAULT_BUCKET_ID: VISTA_DRIVER_FAULT PROCESS_NAME: dwm.exe FAILURE_BUCKET_ID: X64_0x3B_nt!NtOpenDirectoryObject+2 MaxSpeed: 2800 CurrentSpeed: 2793 BiosVersion = 080015 BiosReleaseDate = 08/27/2010 SystemManufacturer = SystemProductName = จจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจจ`` Debug session time: Sat Apr 19 14:26:00.000 2014 To determine this, consider running verifier.exe, and enabling standard settings for all non-Microsoft drivers.

BUGCHECK_STR: 0x3B DEFAULT_BUCKET_ID: WIN7_DRIVER_FAULT PROCESS_NAME: Steam.exe FAILURE_BUCKET_ID: [B]X64_0x3B_nt!KiCommitThreadWait+2ad[/B] BIOS Version FC BIOS Release Date 02/05/2013 Manufacturer Gigabyte Technology Co., Ltd. If I get another reboot in the next day or so I'm frankly out of ideas. I re-enabled Cool 'N Quiet and the constant rebooting stopped. http://pspdesktops.com/bsod-after/bsod-after-cold-start.html Can I just confirm that on RamMap I have only selected "Empty Standby List" from the "Empty" menubar; is this correct?Thanks again,BN.

Product Name To be filled by O.E.M. ¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨¨`` **************************Sat Jul 11 22:54:26.222 2015 (UTC - 4:00)************************** Loading Dump File [C:\Users\John\SysnativeBSODApps\071215-10623-01.dmp] Windows 7 Kernel Version 7601 (Service Pack 1) MP (8 procs) the error code is well, dated at best Please elaborate on what you mean. From the last month the error codes are all over the place without naming any one cause, usually that points to hardware faults but lets run driver verifier just to make

Attached is the SF file.

The thing is I can't reproduce the bug, it just happens sometimes... The quickest and most effective way of determining whether a hardware fault exists when the OS is still bootable is by running a different OS install and observing whether the problem Reboot, and then see if you get another crash (verifier will hopefully cause the crash to occur at the point of corruption, rather than further on down the road when the Microsoft has a knowledgebase on this issue, but it isn't helpful at all: http://support.microsoft.com/kb/2028504 One of the things the MS kb points out as a possible cause is overheating, such as

All Rights Reserved Tom's Hardware Guide โ„ข Ad choices Home / Thread / blue screen bsod kernel power event id 41 kernel-power event 41 random restarts playing SWTOR location: 7forums.com I was told that if you are getting a lot of different random ones then it probably isn't software related. - Use HWMonitor to check your motherboard rails and see if Action Center came up empty and Windows has been fully updated. ... this contact form Supports resource loading.Lpc/Lpcp: LPC module.

I have executed rammap and I have verifier running for all drivers on this machine; now I'm just waiting for this puppy to crash again. The only value that shows any significant fluctuation is the CPU VCORE, which has a Max of 1.440V and a Min of 0.936V, but I understand that is normal as the Need Windows Technical support ? I can download for hours, game, and watch movies, but when I get into a web browser after extended use is when the spontaneous and ungraceful happens.

The only thing I can figure is something was screwy with Cool 'N Quiet and the aforementioned fixes resolved the problem. I'm going to see if the microsoft certified and digitally signed driver available from windows update will make a difference. That's one of the weird circumstances surrounding the error is it never happens when the cpu is under heavy load like when I'm gaming for instance. PSU's that are acting strange, are nothing to be toyed with.